Chapter 2 Connections & SetupChapter 2 Connections & Setup12Things to Consider Before You ConnectProtect Against Power Surges• Connect all components before you plug any of their power cords into the wall outlet or power strip. NEVER plug your TV into an outletthat is controlled by a wall switch.• Turn off the TV and/or component(s) before you connect or disconnect any cables.• Make sure all antennas and cables are properly grounded. Refer to the Important Safeguards sheet packed with your TV.Protect Components from Overheating• Don’t block ventilation holes on any of the components. Arrange the components so that air can circulate freely.• Don’t stack components.• When you place components in a stand, make sure you allow adequate ventilation.• If you connect an audio receiver or amplifier, place it on the top shelf so the heated air from it won’t flow around other components.Position Cables Properly to Avoid Audio Interference• Insert each cable firmly into the designated jack.Important Stand and Base Safety InformationChoose the location for your TV carefully. Place the TV on a stand or base that is of adequate size and strength to prevent the TV from beingaccidentally tipped over, pushed off, or pulled off. This could cause personal injury and/or damage the TV. Refer to the Important Safeguardssheet packed with your TV. It is recommended that you purchase the stand designed for this TV (model RRS50).Use Indirect LightDon’t place the TV where sunlight or room lighting will be directed toward the screen. Use soft or indirect lighting.Connection PicturesThe components used in the connection pictures are for representation only. The input jacks and the output jacks on the back of yourcomponents (VCR, DVD Player, etc.,) might look different than those illustrated.
