Chapter 3 The Remote ControlChapter 3 The Remote Control50The Learning Feature (L1, L2, L3 buttons) — IR LEARNThe Learning feature is used to add codes from another remote control. Your LCOS remote control provides mostof the functions needed, but you can add a small number of additional functions of your choice.Note: Make sure both remote control’s are in the same component mode. For example, if you’re learning abutton from a remote control that came with VCR, make sure both remote controls are in VCR modebecause you’ll be using the learned functions when you’re in VCR mode.Setting Up a Learning Sequence1. Place your LCOS TV remote control and the other remote control so that they face each other. They shouldnot be any more than 2 inches apart.ON-OFFTVVCR2. Press and hold (the backlight button) until CODE SET appears in the remote’s display.3. Press the down arrow button until IR LEARN appears in the remote’s display, then press the OK button (thecurrent mode of the remote control appears in the display window).4. Press OK (LEARNING appears in the LCOS remote’s display for several seconds to allow you to capture theIR data).5. Press L1, L2, or L3 button to designate the button where the functions from the other remote will be stored.You can use buttons other than L2, L2, L3 to learn functions, but you can’t use the following buttons: CLEAR,backlight, M1, M2, M3, TV, DIRECTV, VCR1, VCR2, AUD, AUX, and DVD.6. Press and hold the button on the other remote control, which has the function you want to store. Hold thebutton for at least 3 seconds or until a message appears in the remote’s display.up to 2 inchesapart
