Chapter 3 The Remote ControlChapter 3 The Remote Control56Discrete ClearUse the following steps to delete a discrete code that you added.1. Press and hold (the backlight button) until CODE SET appears in theremote’s display.2. Step through the programming menu by pressing the down arrow button untilDISCRETE CLEAR appears in the remote’s display, then press the OK button.3. Press mode button (also known as a component button) of the discrete codethat you want to clear.4. Press the button assigned to the discrete code you want to delete (DELETEDappears).5. To exit, press and hold the CLEAR button until EXIT SETUP appears in thedisplay.How to Use the Mode Mapping FeatureThe Mode Mapping feature allows you to custom map one component to anothercomponent button. Mode Mapping is another way to program the remote control tooperate another component.1. Press and hold (the backlight button) until CODE SET appears in theremote’s display.2. Step through the programming menu by pressing the down arrow button untilMODE MAP appears in the remote’s display, then press the OK button.3. FROM MODE appears in the remote’s display prompting you to select acomponent button.4. Press the component button of your choice to apply the component to beselected as desired.DIRECTVVCR1VCR2ON•OFF TVDVDAUXAUDM1L1M2L2M3L3FRONTSKIPMUTECH +VOL +VOL -CH - CENTERREARGOBACKFORMATTESTGUIDE INFOAM•FMOK LEVEL +LEVEL -MENUPROGRAMCLEAR1 2 34 5 67 8 90INPUT ANTFUNCTIONSTOP PAUSERECPLAY FWDREVSWAP CHCTRLPIP WHODSPON•OFFDSPMODEDELAY
