Chapter 2 Connections & SetupChapter 2 Connections & Setup23Put Batteries in the Remote ControlFollow these steps whenever you need to install or change the batteries in yourTV’s remote control.1. Remove the cover from the battery compartment.2. Insert batteries into the battery compartment, matching the + and – end ofeach battery (look for the diagram inside of the battery compartment).3. Replace the cover.Plug in and turn onPlug one end of the power cord into the back of the television. Plug the other endinto a wall outlet. Be sure to insert the plugs completely.Note: Plug your television directly into a wall outlet or power strip (or surgeprotector) — don’t plug the TV into a wall outlet that is controlled by a lightswitch.To turn on the TV, press the ON•OFF button. Your LCOS television has to checkmany functions the first time you turn it on (somewhat like a computer bootingup). You’ll notice that it takes a minute or so for the TV to completely warm up.Be patient — it’s worth the wait!Complete the Interactive SetupThe Interactive setup appears when you turn on your TV for the first time. Pressthe arrow buttons (up, down, left, and right) on your remote control to highlight amenu item. Press OK to select the highlighted item.Follow the steps to configure the basics of your system, such as setting up thetime and day, searching for available channels, and setting up speakers. If youever need to run the Interactive Setup again or make adjustments, go to theAssistance menu that’s found in the main menu (for more details, go to page 137in Chapter 7).POWERStep 3Step 4Step 5GOBACKFORMATTESTGUIDE INFOAM•FMOK LEVEL +LEVEL -MENUPROGRAMCLEAR1 2 3Arrow buttonsand the OKbutton
