Radio Shack DX-398 Owner's Manual

283. Repeatedly press PAGE to selectthe page where you want to storethe frequency. 1 or 2 appearsunder PAGE.Notes:• PAGE flashes only when thereceiver is set to SW mode.• If you wait more than 10 sec-onds to press PAGE, PAGEstops flashing.• If you pressed ATS/LW in Step1, PAGE does not appear be-cause there is only one LWpage.4. Press M/MEM. MEMO flashes forabout 12 seconds. The number forthe first available empty memorylocation for the selected pageflashes next to MEMO.Note: If an empty memory loca-tion number does not flash, allmemory locations are full in theband you selected. If this hap-pens, clear a memory location(see “Deleting a Station YouStored” on Page 30) then storethe frequency. Or, to replace astored frequency with a new fre-quency, repeatedly press TUN-ING or to select a newfrequency, press M/MEM, thenpress the number key for thememory location. After a few sec-onds, the receiver beeps andstores the new frequency in thememory location.5. Press ENTER to store the fre-quency in the flashing memorylocation. The receiver beeps anda bracket appears around thememory location number whereyou stored the frequency, to showthat the frequency was storedthere.STORING SWFREQUENCIES INMEMORYFollow these steps to store shortwavefrequencies into empty memory loca-tions in the shortwave page.1. Press METER/SW to select theshortwave band.2. Tune to the frequency you want tostore. The currently selected pagenumber appears under PAGE.3. Press M/MEM. PAGE and MEMOflash for about 10 seconds.