Rangemaster Classic 110 Installation And User Manual

Also see for Classic 110: User guide User guide User's guide & installation instructions User guide & installation & service instructions User's guide & installation instructions

26Repeat from the front and remove the front half of thepoly base. Pull the drawer out to its furthest point. Lift itup and out.Fit the levelling tool on the rectangular adjuster asshown below.LOWER THE FRONT ROLLER by doing 14 complete(360º) turns clockwise. (This means turning andremoving the levelling tool 56 times).Now LOWER THE TWO REAR ROLLERS.First fit the levelling tool on the hexagonal adjusting nutas shown below.Make 10 complete (360º) turns clockwise. (This meansturning and removing the levelling tool 20 times).Make sure you lower BOTH REAR ROLLERS. Thereare two adjusting nuts, one for each roller, at both thefront bottom corners of the cooker.Unfold the rear edge of pack base tray. Carefully pushthe cooker backwards off the pack base and intoposition. Take care not to damage the power cable.Push the cooker close to its final position, leaving justenough space to get behind it.LevellingYou are recommended to use a spirit level on a shelf inone of the ovens to check for level.Place the cooker in its intended position taking care notto twist it within the gap between the kitchen units asdamage may occur to the cooker or the units.The rollers can be adjusted to level the cooker. Toadjust the height of the rear of the cooker use thelevelling tool supplied to turn the adjusting nuts at thefront bottom corners of the cooker.Adjust the height of the front roller to level the cooker.Turn clockwise to raise the cooker and anticlockwise tolower.When you are satisfied with the height and level raisethe front of the cooker by one turn of the front rolleradjuster. Screw down the front feet to meet the floor.Screw the front roller adjuster anticlockwise to raise thefront roller so that the front of the cooker is supportedon the feet, not the front roller, to prevent accidentalmovement of the cooker.Leave the levelling tool on the adjuster with thehandle of the tool facing the rear of the cooker, sothat the customer can use it if they wish to movethe cooker.Replace the drawer by locating on side runners andpush in.Fit the HandlesRemove the 4mm Allen screws from the doors with thehexagon key tool. Use the screws to fit the doorhandles.