Rangemaster Classic 110 Installation And User Manual

Also see for Classic 110: User guide User guide User's guide & installation instructions User guide & installation & service instructions User's guide & installation instructions

29Fitting the oven burner trim(supplied with some models only)The loose oven burner trim hooks onto the front of theoven burner bracket.Oven checkThe clock must be set to the time of day before theovens will work.Press and hold as above.At the same time, press - or + until the correct timeshows.Don’t forget it’s a 24 hour clock.If you make a mistake or press the wrong button, turnoff the power supply for a minute or two and startagain.CONTROL KNOB (THERMOSTAT) CHECKIf (AUTO) is flashing, press and release the manual( ) button. Check each oven in turn. Push in and turnthe control knob to Mark 9. A series of sparks will occurat the oven electrode and when the oven burner lightsthe sparking will stop. A small flame will appear on theoven burner, but as this flame is ‘sensed’ by the flamesupervision device, the gas flow will come on full aftera short delay. Heat each oven for 10 minutes at Mark 9then turn to Mark 1 and check that the flame size hasreduced. Turn off each oven and check that the ovenburner goes out.TIMER AND SOLENOID CHECKAutomatic Operation of Timer: The gas supply to eachoven can be controlled by the timer. Set a ‘cookingperiod’ time by pressing and releasing the ( ) buttonand using the + button to give a time of 2 minutes. Bypressing and releasing the ‘stop time’ button ( ) thestop time is displayed. Add 3 minutes to this time byusing the + button. The display will automaticallychange to show the time of day, the cooking symbol( ) will go out and (AUTO) will show.Push in and turn one of the oven knobs to Mark 9, thetimer will run until the ‘cook period’ starts, when theoven solenoid will open and the burner will lightautomatically. The cooking symbol ( ) will show. Atthe end of the ‘cooking period’ the solenoid will close,the oven burner will go out and the beeper will sound(the beeper may be stopped by pressing the timer ( )button). The flashing (AUTO) symbol is a reminder toreset to manual operation. Pressing the reset’ button( ) once to stop the beep and a second time to returnto manual, turn off the oven knob.CONTROL KNOB (THERMOSTAT) CHECKSet timer to manual. Check each oven in turn. Push inand turn the control knob to Mark 9. A series of sparkswill occur at the oven electrode and when the ovenburner lights the sparking will stop. A small flame willappear on the oven burner, but as this flame is ‘sensed’by the flame supervision device, the gas flow will comeon full after a short delay. Heat each oven for 10minutes at Mark 9 then turn to Mark 1 and check thatthe flame size has reduced. Turn off each oven andcheck that the oven burner goes out.Fitting the plinthLoosen the 3 screws along the front bottom edge of thecooker. Hook the central keyhole over the centralscrew. Twist and fit each end keyhole over theirrespective screws. Tighten the fixing screws.Customer carePlease complete your details in the inside cover of thisGuide. Then replace this Installation Guide back in theCustomer Care Pack in the correct position. Pleaseinform the user how to operate the cooker and handover the Customer Care Pack.Thank you.

/ 32

Related manuals for Rangemaster Classic 110