Regency P36E-NG10 Owners & Installation Manual

Contents

Regency P36E-NG10 Owners & Installation Manual Manual pdf 37 page image

P36E-10 Zero Clearance Direct Vent Gas Fireplace | 3737|installationCONVERSION FROM NG TO LPP36E-10 USING SIT 885 GAS VALVEEach Kit contains one LPConversion KitLP Conversion Kit Contains:Qty. Part # Description1 904-390 Burner Orifice #521 918-590 Decal “Converted toLPG”1 908-528 Red “LPG” label1 904-529 5/32” Allen Key1 911-011 Hi/Lo regulator1 910-101 LPG Injector (Pilot Orifice)1 919-473 Instruction SheetConversion from NG to LPGfor P36E using SIT 885 NOVA Gas ValveTHIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTERIF IN DOUBT DO NOT DO THIS CONVERSION !!Installation of the LPConversion Kit:1) Shut off the gas and electrical supply.2)a) Remove the safety screen and face-plate, if installed.b) Open and remove the glass door.c) Remove the logs, embers, and brickpanels (if used).8) Reinstall new burner orifice LP stamped#52 and tighten6) Unscrew the pilot orifice with the allenkey; then replace with the LP pilot orificeand the pilot cap, provided in the kit.7) Remove burner orifice with a 1/2"wrench. Use another wrench to hold onto the elbow behind the orifice. Discardorifice.Burner OrificeRemove the 2 screws, push Burner Assemblyto the left and lift out.3) Remove the 2 screws holding the BurnerAssembly to the firebox base. Push theBurner Assembly to the left and lift out.Installer Notice:These instructions must be leftwith the appliance.4) Remove the wire clip below the pilot cap.Pilot retainer clip5) Pull off the pilot cap to expose the pilotorifice.9) Disconnect the cable from the pressureregulator motor.Motor wire10) Remove Hi/Lo pressure regulator byremoving 2 screws as shown below.Reverse steps to install LP pressureregulator. Reattach pressure regulatorwire.11) Attach the label “This unit has beenconverted to LPG” near or on top of theserial # decal.12) Replace yellow “NG” label with red“LPG” label.13) Reverse steps 3 - 1.14) Check for gas leaks.15) Check inlet and outlet pressures.16) Check operation of flame control.P36E