Regency P36E-NG10 Owners & Installation Manual

Contents

Regency P36E-NG10 Owners & Installation Manual Manual pdf 44 page image

44 | P36E-10 Zero Clearance Direct Vent Gas Fireplace|44installationVIGNETTE FINISHING TRIM INSTALLATION*If finishing the unit Flush with Vignette Finishing Trim - remove top nailing strip from unit if installed–use nailing strip supplied with top trim piece. Sidenailing strips are bent around side trim piece in flush finish application. See nailing strip section in manual for details.VIGNETTE FINISHING TRIMNOTE: Remove the safety screen, Vignette Faceplate and glassdoor prior to installing the Finishing Trim.1. Install the Finishing Trim sides as shown in the diagram, line upthe holes in the side trim with the holes in the firebox side.2. Secure with 2 screws each side.3. Loosen the 3 screws in the top inside edge of the firebox.4. Slide the Finishing Trim Top over the Side Trim pieces and fit thebottom bracket slots over the screws. Tighten the 3 screws tosecure.5. Hook Vignette Faceplate brackets into place.7. Hook Vignette Faceplate brackets into place (see specific instruc-tions in unit manual).6. Install the lower finishing trim (if required)–secure with fourscrews.Completed install*If finishing the unit Flush with Vignette Finishing Trim - remove top nailing strip from unit if installed–use nailingstrip supplied with top trim piece. Side nailing strips are bent around side trim piece in flush finish application.Secure with 2 screwseach side919-556 04.16.151Important: See clearance/framing requirements on nextpage when using the Vignettte Finishing trim