Regency P36E-NG10 Owners & Installation Manual

Contents

Regency P36E-NG10 Owners & Installation Manual Manual pdf 57 page image

P36E-10 Zero Clearance Direct Vent Gas Fireplace | 5757|maintenance5) Disconnect the inlet gas line.6) Disconnect the EV1, EV2, and ground wiresfrom the valve - as shown below.7) Disconnect cable from pressure regulator motor.8) Disconnect spark electrode and sensingelectrode wire from DFC board.REMOVING VALVE1) Shut off the gas and electrical supply.2) Remove the faceplate, safety screen andglass door–see detailed instructions inmanual.3) Remove the logs.4) Remove the burner/grate assembly byremoving the two screws and then lift theburner assembly out.Diagram 1: Remove the left and right screwsand then lift out the burner/grate assembly.9) Remove the rear log stand by removing the2 screws.10) Remove the 10 screws securing thevalve tray assembly in place (Diagram2) and then lift the entire assembly out(Diagram 3).Diagram 2: Rear Log Stand andValve Tray Assemblyscrews Valve Tray AssemblyRear Log Standscrews12) Replace with a new a valve tray assemblyand reverse steps 9 - 1.EV1 EV2Ground11) Lift out valve tray.