Salus FC600 Instruction Manual

Also see for FC600: Quick guide Full user manual

50 Fan Coil FC600 Instruction Manual4.7.1 In offline Mode (with no Internet connection)MPress the buttons for 3 seconds.MPress OK. You should enterInstaller Mode.MThe digits on the screen will flash.Using the up/down keys enterpass 49.MThe d00 will flash.Installer Mode is an advanced menu, where the user can access all the thermostat's settings. It can be accessedfrom the device when FC600 is working in local mode (without Internet connection). To enter Installer Mode(in offline mode ONLY), follow the steps below:There are numerous settings that can be set and changed, please find a description of all the function later inthe chapter. The dxx parameter is the number of the setting and the number above is the value given to thesetting. In the table you will find all the settings and their values described.4.7.2 Switching from non-programmable to programmable thermostatMPress the buttons for 3 seconds.MPress OK. You should enterInstaller Mode.MThe digits on the screen will flash.Using the up/down keys enterpass 49.MThe d00 will flash. Press OKMThe d00 value will flash. Usingthe up/down keys enter 1.The Fan Coil thermostat is now inprogrammable mode.MThe new value will flash. Long press OK to makethe selection and go to home screen.MAfter first power up, FC600 is non programmable by default. If you would like to switch it to programmablethermostat in local mode, please follow below steps:4.7 Installer Parameters3sec3sec3sec3sec3sec3sec3secNote: This mode (Installer Mode) is NOT available on the device when the Fan Coil is connected to theInternet. To change the installer parameters when the device is connected to the App, please see the pagebelow.