9 Fan Coil FC600 Instruction ManualAfter the Fan Coil (FC600) has been installed accordingly to your system (for the installation and differentsystems description please refer to the Installer Section in chapter 4) it will go into STANDBY Mode. To startusing your FC600 and adjust room temperature, create schedules and operate the fan you will need to wakeit up. Simply press the button for 3 seconds. The icons on your screen will show up depending on yoursettings. The time should be 12 AM. Note: Press any button to activate the LCD first!M MM MPress arrows to check setpoint The current setpoint temperaturewill start flashingSetpoint temperature is the temperature you want to set or the temperature set by the program. Under yourhome display, press or to view the set point temperature. When the program is running, after theshort press of the Up/Down arrows, the LCD will show the current program setpoint, with the Set icon.MPress Up/Down to increase/decrease setpointMPress OK to save and exitNote: By default, if you are using the thermostat without the Internet, it will be non-programmable, meaningthat you cannot set programs. The thermostat can be switched to programmable mode by changing the d00parameter from 0 to 1 in Installer Mode. Find more information in the Installer Section.For non-programmable thermostatMThe thermostat will now return to home screen and it will follow new setpoint.2.5 Temperature Setpoint2.4 Power Up3 sec00:0000:0000:00.