59 Fan Coil FC600 Instruction ManualIf you want to add the FC to the UGE600 after you set it up, you need to use the 55 code, and than you selectUG YES, and then you confirm PAIR to start joining the UG. On the App you should see all the settings whichhave been already done in the past, when you configured the FC600 without the UG. Please see the detailedprocedure as shown. Make sure your UG is connected to the system and you have the App installed.MPress the buttons for 3 seconds.MPress OK.MThe digits on the screen will flash. Using the up/down keys enter pass 55.MPress OK.MShort press button to confirm pairing. At thispoint you should go to the App in order toconfigure your Fan Coil.Theantenna signwill appear inthe corner of thescreenMake sure that your Universal Gateway is added to theApp. The led of the Gateway should be steady blue. Onceyou have that installed, go to your Fan Coil and beginparing it with the UG and adding it to the App.To begin the pairing process the gateway should be plugged into the power source and connected to theInternet. Also, make sure that the UG is added to your Salus Smart Home App. For the installation of the UniversalGateway, please refer to the UG600/UGE600 manual on salus-manuals.com3sec3sec3sec4.9 Switching from offline to online modeNow go to the App. Tap menu icon