Samsung DCS-VIP User Manual

Also see for DCS-VIP: User guide Quick guide

Contents

DCS-VIP User Guide68! Primary Gateway : Enter the gateway, the IP address of the DCS-VIP .NAT SetupNAT (Network Address Translation) will enable more than two users to connect tothe network using a single user account. This function is valid only for ISPconnection. On this screen, set the following parameter values and click the Setbutton.NAT Table Configuration! Global IP Address : For the initial link to the ISP, set this IP address (10.0.0.1).If the link succeeds, the ISP will automatically allocate an IP address, which will besaved in this field as the NAT global IP address.! Subnet Mask : For the initial link to the ISP, use any subnet mask. When the ISPallocates a NAT global IP address, the subnet mask value will automatically be setup. In general, 255.255.255.0 is used as subnet mask.! NAT Entry Status$: To generate the NAT table defined on this screen, select‘CREATE’, and if you want to delete it, select ‘DELETE'.! Network IP Address, Subnet Mask : Enter the DCS-VIP network address rangeand subnet mask. You must enter the numbers as formatted in the followingexample.168.219.81.0,255.255.255.0;NAT Global Configuration! NAT Port Translation$: To perform port conversion according to addressconversion of NAT Global IP address., select ‘YES’! NAT Feature : To use NAT function, select 'ENABLE'.Group 2 (IPX OptionGroup 2 (IPX OptionGroup 2 (IPX OptionGroup 2 (IPX Option))))You can set up the options for IPX, which is the network layer protocol for NovellNetWare. Set the following parameter values and click the Set button.IPX SetupWhen you configure Ethernet using the DCS-VIP, you need to set the followingparameters if you want to use the devices connected to each other in the NetWarenetwork environment.! IPX Internal Network Number : IPX network number of Ethernet itself. MACaddress of system is mainly used. The network number of the IPX address is 32-bithex values separated with dots.! IPX Node Number : IPX node number of Ethernet itself. The node number of theIPX address is 48bit hex values separated with dots.! IPX Global Administrative Status : To operate Ethernet IPX, select 'ENABLE'.! IPX Port Network Number (Hex Value) : Enter the IPX number of network onthe side of Ethernet.! IPX Port Administrative Status : To operate Ethernet IPX number, select'ENABLE'.PPP SetupFor PPP connection in NetWare network environment PPP, set up the parametersbelow.Subnet maskNetwork address