Samsung DCS-VIP User Manual

Also see for DCS-VIP: User guide Quick guide

Contents

DCS-VIP User Guide70! Network Number : This indicates the IPX network number of the destinationnetwork.! MAC Address of the Next Hop Router : Enter the NIC(Network Interface Card)address of the next hop.NoteHops are routers that IP packets go through before arriving at thedestination network from the transmitting network.! Transport Delay to reach the Destination Network : Enter the time takenbefore arriving at the destination network by tick unit.! Number of Hops : Enter the number of hops necessary for arriving at thedestination network.! Static Route Status : To use the routing path information set up on this screen,set this to ‘ENABLE’.After finishing setting up all the parameters above, click on the SET button. If youwant to create a routing table for another Circuit, click on the NEXT button to enterthe new routing information. Then, click the SET button.IPX Service SetupOn the IPX Service Setup screen, you can set up IPX Static Server configuration.! Circuit Index : This indicates the eigen number to discriminate each logicalCircuit. This number is the ‘Circuit Index’ parameter number on the IPX CircuitSetup menu.! Server Name : This indicates the service name of server.(e.g. File server, Print server etc.)! Service Type : This indicates the service type.! Server Network Number : Enter network number of IPX address.! Server MAC Address : Enter node number of IPX address.! Service Socket : Enter the socket number of IPX address.! Next Hop Router Address : Enter the next hop router address.! Number of Hops : Enter the number of hops necessary for arriving at thedestination network.! Service Entry Status : This shows whether this Static service is valid or not.After finishing setting up all the parameters above, click on the SET button. If youwant to create an IPX Static Server for another Circuit, click on the NEXT button toenter the new IPX Static Server information. Then, click the SET button.