Samsung OfficeServ 7200 Installation Manual
Also see for OfficeServ 7200: System administration guideUser guideUser instructionUser guideUser manual
                                                                                                                       |
CHAPTER 2. Ошибка! Используйте вкладку "Главная" для применения 제목 1 к тексту, который должен здесьотображаться.2-2 © SAMSUNG Electronics Co., Ltd.2.3 Installing in a RackThis section describes how to install the OfficeServ 7200 cabinet inside a 19-inch rack.2.3.1 Cautions for InstallationTake the following cautions when installing the OfficeServ 7200 cabinet inside a rack: The 19-inch rack should be a standard electric equipment rack. When using an enclosed-type rack, check if the rack is properly ventilated.Vents should be equipped on the side of the rack and fans should be attached toventilate cool air into the rack. Take special caution with an enclosed-type rack that has vents on top of the rack sincehot air coming out of the vent may enter the intake vent of a system installed abovethe rack. When using an open rack, do not block the entrance of a port or fan of the OfficeServ7200.2.3.2 Required Tools A middle-sized cross screwdriver A bracket and three screws for attaching cabinet Two brackets and six screws for attaching rack Two screws for fasteningFigure 2.1 Tools Required for Rack Installation |
Related manuals for Samsung OfficeServ 7200
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine