Samsung OfficeServ 7200 Installation Manual
Also see for OfficeServ 7200: System administration guideUser guideUser instructionUser guideUser manual
                                                                                                                       |
OfficeServ 7200 Installation Manual© SAMSUNG Electronics Co., Ltd. 3-19J21J3 J41 1Interlocking with IP phones via PLIMIf the system interworks with IP phones from the internal power via the PLIM, upto 16 IP phone can be interworked and the remained Digital Phone (DGP) can beinterworked up to 24 DGP on the basis of 2-line LCD.3.3.1.4 PLIM2PLIM2 (PoE LAN Interface Module) can use PSU (Power Supply Unit) or an externalrectifier and selects the power supply source by using shunt pins.Jumper Setting When using the internal rectifierThe shunt pins (J2, J3 and J4) are connected between pin1 and pin2.Since the available capacity is limited to PSU, the use of ports is limited to 16 portsand the use of digital phones is, also, limited. (For more information on the limitationabout the use of digital phone phones in accordance with the use of PLIM2 port,contact your dealer.) For the use of an external rectifier: The shunt pins (J2, J3 and J4) are connectedbetween pin2 and pin3. There is no restriction on the use of an external rectifierbecause each of them can supply the current of 10 A. Limit each current runningthrough PLIM2 ports below 0.1 A and in the module below 1.6 A.Each jumper is numbered in ascending order from the marked ‘1’ in the following figure.Figure 3.16 Setting the jumpers of PLIM2 |
Related manuals for Samsung OfficeServ 7200
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine