Samsung OfficeServ 7400 General Description Manual

Also see for OfficeServ 7400: System administration guide User guide User instructions Technical manual General description

Contents

SplitA keyset user can “split” a conference into separate outside calls, then speak with each caller privately. Thenthe individual calls can be conferenced again in any combination. NOTE:This feature requires individual trunkbuttons and auto-hold must be enabled.CONFERENCE GROUPUsers that have a 5112L-ITP large screen keyset or OfficeServ Softphone may have 1-5 conference groupsprogrammed. Each conference group can have up to 4 parties assigned. They can be extensions in the sys-tem or telephone numbers of people outside the system. Press the Conference Group button to call all mem-bers of the group at the same time. Status indications appear in the display. Press the corresponding softkeyto drop or call parties as desired (maximum 100 users).CUSTOMER SET RELOCATIONCustomer Set Relocation allows the customer to exchange or swap similar stations in the OfficeServ 7400without wiring changes. All individual station assignments such as trunk ring, station group, station COS, sta-tion speed dial, button appearances, call forwarding, etc. will follow the Customer Set Relocation program.DATA SECURITYSingle line extensions used with modems and facsimile machines can be programmed so that they will notreceive any system-generated tones that would disrupt data transmissions. In addition, these devices receiveDCS C.O. ringing pattern instead of intercom ring pattern. Devices connected to an SLI card receive a discon-nect signal upon termination.DATABASE PRINTOUTA copy of the customer database can be obtained by using WebMMC. This information can be directed to aprinter or the PC screen and may be done either on-site or remotely. A complete database or specific datablocks may be obtained.DAYLIGHT SAVING TIME-AUTOMATICThe system has a table that can be programmed with the daylight savings change dates for up to 10 years.At 2:00 am on these dates the system will automatically adjust the system clock to match daylight savingstime. If no dates are programmed the clock will not change.DIALED NUMBER IDENTIFICATION SERVICE (DNIS)When DNIS service is provided on an incoming E&M trunk the OfficeServ 7400 can route calls based on thenumbers received. (See DID)DIRECT IN LINESOutside lines may be programmed to bypass the operator(s) and ring directly at any station or group of sta-tions.DIRECT INWARD DIALING (DID) (T1 or ISDN PRI Service Only)The term Direct Inward Dialing refers to types of digit steered inbound call handling.These are DID, Both WayDID, Dialed Number Identification service (DNIS) and Direct Dial In (DDI). The OfficeServ 7400 supports thetypes described below.4.14