Can not turn off the Light Effect on the • Adjust the Light Effect option in the setup menu. Options are : Off, In Standby, Watching "IV andfront bezel. (Below SAMSUNG Logo) Always.• Light Effect is not availableon all models.A "Mode Not Supported" message • Check the supported resolution of the T_, and adjust the external device's output resolutionappears, accordingly. Refer to the resolution settings on page 12 of this manual.Caption on TV menu is greyed out. • Caption can not be selected in the TV menu when connected via HDMI or Component (p. 26).• Caption must be activated on the external device (p. 26).There is a plastic smell from the T_ • This smell is normal and will dissipate over time.The TV Signal Information is unavailaUe • This function is only availablewkh digital channels from an Antenna / RF/Coax connection (p. 28).in the Self Diagnostic Test menu.The TV is tilted to the side. • Remove the base stand from the TV and reassemble it.The channel menu is greyed out • The Channel menu is only available when the TV source is selected.(unavailable).Your settings are lost after 30 minutes or • If the TV is in the Store Demo mode, it will reset audio and picture settings every 30 minutes. Changeevery time the TV is turned off. the settings from Store Demo mode to Home Use mode in the Plug & Play procedure. Press theSOURCE button to select "IV mode, and go to MEHU -_ Setup _ Plug & Play _ ENTER _ (p. 8).You have intermittent loss of audio or • Check the cable connections and reconnect them.video. • Loss of audio or video can be caused by using overly rigid or thick cables. Make sure the cables areflexible enough for long term use. If mounting the TV to a wall, we recommend using cables with 90degree connectors.You see small particles when you look • This is part of the product's design and is not a defect.closely at the edge of the frame of the T_The PiP menu is not available. • PIP functionality is only availablewhen you are using a HDMI, PC or Component source.POP (TV'sinternal banner ad) appears on • Select Home Use under Plug & Play mode. For details, refer to Plug & Play Feature (p. 8).the screen.This TFT LED panel uses a panel consisting of sub pixels which require sophisticated technology to produce, However,there may be a few bright or dark pixele on the screen, These pixels will have no impact on the performance of theproduct,English 63