Samsung WEC8500 Maintenance Manual

Also see for WEC8050: Operation manual Operation manual Operation manual Operation manual Operation manual

Contents

WEC8500/8050 Maintenance Manual Version 5.1Samsung Electronics America page 74 of 875.2 Problem with Tx Power SettingsSymptomsPower setting cannot be configured on the AP.Possible Causes The AP is not connected. CAPWAP state of the AP is not RUN (5) Tx power setting range is different for each country, AP model, or channel.Solutions1) Execute the ‘show ap summary’ command to check that the AP is connected.WEC8500# show ap summaryAP Mgnt interface IP : 10.64.55.1 (vlan1.192)AP_ID CFG_NAME AP_NAME MAC_Address IPv4Addr State Location====== ========= =============== ================= ============= ===== ========1 ap_1 AP_f4d9fb23d049 f4:d9:fb:23:d0:49 10.64.55.103 1/1/52 ap_2 AP_f4d9fb23cfc9 f4:d9:fb:23:cf:c9 10.64.55.57 1/1/53 ap_3 AP_f4d9fb23cbf9 f4:d9:fb:23:cb:f9 10.64.55.102 1/1/5If the AP is shown, setup the AP by referring to AP Settings2) Execute the ‘show ap summary’ command to check the CAPWAP state of the AP.WEC8500# show ap summaryAP Mgnt interface IP : 10.64.55.1 (vlan1.192)AP_ID CFG_NAME AP_NAME MAC_Address IPv4Addr State Location====== ========= =============== ================= ============= ===== ========1 ap_1 AP_f4d9fb23d049 f4:d9:fb:23:d0:49 10.64.55.103 1/1/52 ap_2 AP_f4d9fb23cfc9 f4:d9:fb:23:cf:c9 10.64.55.57 1/1/53 ap_3 AP_f4d9fb23cbf9 f4:d9:fb:23:cb:f9 10.64.55.102 1/1/5If the CAPWAP state of the AP is not RUN (5), solve the problem by referring toCAPWAP Settings