18_ Installing your washerInstalling your washerDrainSamsung recommends a standpipe height of 18 in (46 cm). The drain hose must be routedthrough the drain hose clip to the standpipe. The standpipe must be large enough to accept theoutside diameter of the drain hose. The drain hose is attached at the factory.FlooringFor best performance, your washer must be installed on a solidly constructed floor. Woodenfloors may need to be reinforced to minimize vibrations and/or unbalanced loads. Carpeting andsoft tile surfaces are contributing factors to vibrations and the tendency for your washer to moveslightly during the spin cycle.Never install your washer on a platform or poorly supported structure.Surrounding temperatureDo not install your washer in areas where water may freeze, since your washer always retainsome water in the water valve, pump and hose areas. Frozen water in the lines can causedamage to the belts, the pump and other components.Alcove or closet installationTo operate safely and properly, your new washer requires the following minimum clearances:Sides 1 in / 25 mm Rear 5.9 in / 150mmTop 17 in / 432 mm Front 2 in / 51 mmIf both the washer and a dryer are installed together, the front of the alcove or closet must havean unobstructed air opening of at least 72 in² (465 cm²). Your washer by itself does not require aspecific air opening.1 in.(2.5 cm)1 in.(2.5 cm)1 in.(2.5 cm)27 in.(68.6 cm)27 in.(68.6 cm)2 in.(5 cm)5.9 in.(15 cm)34.1 in.(86.5 cm)17 in.(43.2 cm)Recessed area Side view - closet or confined areaWARNING
