24_ Installing your washerInstalling your washerSTEP 5Powering your washing machinePlug the power cord into a wall socket, an AC 120V / 60Hz approved electrical outlet protectedby a 15-amp fuse or circuit breaker. (For more information on the electrical and groundingrequirements, refer to the “Electrical supply and grounding” section on page 17.)When the power plug is connected, the Samsung logo is displayed for about 15 secondsbefore the screen turns off. Press the Power button to use your washer.The process shown in this figure is a preparation step for using your washer. It is not anindication of a failure.Test runMake sure that you install your washing machine correctly by running the Rinse+Spin cycleafter the installation is complete.STEP 6Calibration modeBefore using Calibration mode, be sure to take all items out of the drum.Your Samsung washing machine automatically detects the weight of the laundry.For a more accurate weight detection, please run Calibration Mode after the installation.To run Calibration Mode, follow these steps:1. Turn on the washer.2. Tab Settings and then Calibration Mode.3. Remove any contents in the tub and close thedoor.4. Tab Calibration Ready5. Press the Start/Pause button to runCalibration Mode.6. The drum rotates clockwise andcounterclockwise for approximately 3 minutes.7. When Calibration Mode is finished, the “Cyclecomplete” message appears on the display andthe washing machine turns off automatically.The washing machine is now ready for use.
