Installing your washer _2101 INSTALLING YOUR WASHERSTEP 3Connecting the water and the drainConnecting the water supply hoseDo not connect multiple water supply hoses. This may result in a water leakage and electricshock due to the water leakage. If the hose is too short, replace the hose with a longer,high pressure hose.1. Connect one end of the COLD water supply hose to theCOLD water supply intake at the back of the washer.2. Tighten part (A) by hand until it is snug, then make two-thirds of a turn with a wrench.3. On the other end of the hose, check for one rubber washerper hose and install each water supply hose to the faucet.Make sure the hose with the printed word HOT isattached to the HOT faucet.4. Tighten part (A) by hand until it is snug, then make two-thirds of a turn with a wrench.For the correct water use, connect both the HOTand COLD water faucets. If either or both are notconnected, an “nF” (no fill) error can occur.After you have connected the water supply hose tothe faucet, ensure that it is connected correctly bypulling the water supply hose downwards.Check if the water supply hose is not twisted or bent.If the hose is twisted or bent, there is a danger of awater leakage and electric shock due to the waterleakage.5. Turn on the HOT and COLD water supply and check allconnections at the water intake and the faucet for leaks.Cold hotRubberWasherACAUTIONWARNING
