English 3Network Connection ProcedureTo operate the DVR through a network, first setup the DVR and computer and then perform the predetermined connectionoperations using the computer.1 NETWORK SET Settings of DVRSelect NETWORK SET from the main menu of the DVR andmake the following settings to allow the DVR to work with anetwork connection. Refer to the instruction manual of theDVR for details.1 NETWORK CONTROLTo use network operation change to "ON (NETWORK)"or "ON (DVR)".Selections:• ON (NETWORK):Gives priority to network operations and allows allusers (ID1 to ID3) to access.• ON (DVR):Gives priority to DVR operations and limits the userswho can access the network to ID1 users only.• OFF:Network operations are not allowed.2 NETWORK STATUSSets whether or not the "NETWORK CONTROL"message will display on the monitor connected to theDVR when connected to the network.3 IP ADDRESS/SUBNET MASK/GATEWAYSet each item in a range of 0 to 255.Ask the network administrator for IP addresses andsubnet masks required to set the network.4 PORTNormally set to "80".5 ID/PASSWORDAn individual PASSWORD can be set according to theoperation authority.2 TCP/IP Settings of the ComputerSetup TCP/IP according to each OS for the computer beingused.The setup example shown below is for Windows XP.1 Click [Network and Internet Connections] of[Control Panel].The "Network and Internet Connections" screen willdisplay.2 Click [Network Connections].The "Network Connections" screen will display.The settings of the LAN card being used (Ethernetadapter) display in the [LAN or High-Speed Internet]column.The IP address, subnet mask, gateway, port, andpassword settings can be changed using thecomputer. (Refer to P34) SET>NETWORK CONTROL : OFFNETWORK STATUS : ONIP ADDRESS : 192.168. 0. 1SUBNET MASK : 255.255.255. 0GATEWAY : 0. 0. 0. 0PORT : 00080ID PASSWORD (4-8)ID1 : 1111----ID2 : 2222----ID3 : 3333----12354