Sanyo DSR-M814 Instruction Manual

Also see for DSR-M814: Service manual addendum Service manual

Contents

CONTROL TERMINAL SPECIFICATIONS67APPENDIXThe connections for a remote control circuit are shownbelow. Connect the remote control to the REMOTE terminaland C (ground) terminal.Use a resistance of 1/10 ohms or more and with a Dranking (precision 0.5% or finer).SW16 operates the same as the [REC/STOP] button on thedigital video recorder. When the switch is turned on whilenot recording, recording begins. When the switch is kept onfor 2 seconds or more while recording, recording isstopped.Alarm sensors can be connected to the ALARM IN 1 to 4terminals and C (ground) terminal.Connect the control terminals by cables as shown below.Terminal No.8: COMMON9: SERIES REC IN10: NON REC OUT/SERIES REC OUTRemote control connectionsAlarm sensor connections1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 192202203003604706808201.2k1.8k2.2k3.3k4.7k7.5k13k27k68kSW 1SW 2SW 3SW 4SW 5SW 6SW 7SW 8SW 9SW 10SW 11SW 12SW 13SW 14SW 15SW 16Key Resistance Corresponding buttonSW1 220 Ω CHANNEL button 1SW2 440 Ω CHANNEL button 2SW3 740 Ω CHANNEL button 3SW4 1100 Ω CHANNEL button 4SW5 1570 Ω QUAD/SEQUENCESW6 2250 Ω AUDIOSW7 3070 Ω SEARCHSW8 4270 Ω MENUSW9 6070 Ω EXIT/OSDSW10 8270 ΩSW11 11570 ΩSW12 16270 Ω (REVIEW)SW13 23770 Ω (CUE)SW14 36770 Ω STILLSW15 63770 Ω PLAY/STOPSW16 70570 Ω REC/STOP1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19To sensor 1To sensor 2To sensor 3To sensor 4C (ground) terminalSeries recording connections5 6 7 8 9 10 11 12 13 5 6 7 8 9 10 11 12 132nd DVR1st DVRTo 3rdDVRe00_VDH_M814.book Page 67 Thursday, October 28, 2004 9:59 AM