9This LCD TV uses nominal input voltages of 110-242V AC. ThisLCD TV automatically selects the correct input voltage. It isdesigned to work with single-phase power systems. To reducerisk of electric shock, do not plug into any other type of powersystem. Consult your authorized dealer or service station if youare not sure of the type of power being supplied.Connect the LCD TV with all peripheral equipment beforeturning the LCD TV on.CAUTIONFor safety, unplug AC power cordwhen the LCD TV is not in use.CONNECTING LCD TVCONNECTING AC POWER CORDTo the AC Outlet (110 - 242V AC).Pull the AC power cord out from the LCD TV. The AC outletmust be near this equipment and must be easily accessible.INSTALLING STANDPlease according to the following procedure to installing stand.AC POWER CORDBe careful of the panel. Suggest to putdown the panel side on the cushion or othersoft material before installing the stand.To align the corresponding pilot holes and fix thestand by screws.Screws B for LCD-32K40-TD: 4 pcsScrews A for LCD-42K40-TD: 2 pcsScrews B for LCD-42K40-TD: 4 pcsInstalling of stand is completed.1 23Note: Screws A are just forLCD-42K40TDABBPREVENTING THE TV FROM FALLING OVERMountingscrew CBandBandMountingscrew CMountingscrew CMountingscrew CCarry out the steps given below to stabilize the TV that it willbe safe in the event of a disaster such as an earthquake, andso that it will not fall over during normal use.Use the marketed bands and screws C to fasten the TVsecurely to the TV stand etc.Screw AScrew BScrew C