Sanyo PLC-SW30 Owner's Manual

Also see for plc sw30 - SVGA LCD Projector: Owner's manual Specifications Service manual Service manual Service manual

12This projector uses nominal input voltages of 100-120 V or 200-240V AC. This projector automatically selects the correct inputvoltage. It is designed to work with single-phase power systemshaving a grounded neutral conductor. To reduce risk of electricalshock, do not plug into any other type of power system.Consult your authorized dealer or service station if you are not sureof the type of power supply being in use.Connect a projector with a peripheral equipment before turning aprojector on. (Refer to page 15 –16 for connection.)CAUTIONFor safety, unplug the AC Power Cord when an appliance is not used.When this projector is connected to the outlet with the AC Power Cord,an appliance is in Stand-by Mode and consumes a little electric power. Connect AC Power Cord (supplied) to theprojector. The AC outlet must be near thisequipment and must be easily accessible.Note:AC Power Cord must meet requirement of the country where you use the projector.Confirm an AC plug type with the chart below and proper AC Power Cord must be used.If supplied AC Power Cord does not match your AC outlet, contact your sales dealer.To POWER CORDCONNECTOR on yourprojector.Projector side AC Outlet sideGroundTo the AC Outlet.(120 V AC)For Continental EuropeFor the U.S.A. and Canada For the U.K.To the AC Outlet.(200 - 240 V AC)To the AC Outlet.(200 - 240 V AC)Connecting the AC Power CordPreparationDownloaded From projector-manual.com Sanyo Manuals