19Connect the projector's AC Power Cord into an AC outlet. ThePOWER indicator flashes in a moment and then turns red.Press POWER ON-OFF button on the top control or the remotecontrol. The POWER Indicator turns green, and the cooling fansstart to operate. The starting display appears on the screen andthe count-down starts.23Turning Off the ProjectorPress the POWER ON-OFF button on the top control or theremote control, and the message " Power off? " appears on thescreen.Press the POWER ON-OFF button again to turn off theprojector. The POWER indicator starts to flash red and continueswhile the cooling fans are operating. (for approx. 90 seconds)12TO MAINTAIN THE LIFE OF LAMP, ONCE YOU TURNPROJECTOR ON, WAIT AT LEAST 5 MINUTES BEFORETURNING IT OFF.DO NOT DISCONNECT THE AC POWER CORD WHILECOOLING FANS ARE RUNNING OR BEFORE POWERINDICATOR LIGHTS RED. OTHERWISE IT WILL RESULT INSHORTENING LAMP LIFE.Turning On the Projector1 Complete peripheral connections (with a computer, VCR, etc.)before turning on the projector.3 When the projector is cooled down enough to be turned onagain, the Power indicator turns red again. Then you candisconnect the AC power cord.26– The starting display disappears after 30 seconds.– The starting display can be changed. ( ☞ " Capture " P36 )Power off?Message disappears after 4 seconds.Basic OperationAfter the count-down, the input source that was selected lastand the Lamp mode status appear on the screen.4Note :– When the Power Management function is ON, the projector detects signalinterruption and automatically turns off the projection lamp. ( ☞ P 37 )– The projector cannot be turned on during the cooling period with thePOWER indicator flashing red. You can turn it on again after the POWERindicator lights red.– Do not use the projector for more than 24 hours continuously. Turn off theprojector at least once in 24 hours and give it a rest. Continuous use mayresult in shortening the lamp lifetime.– This projector detects internal temperature and automatically controls therunning speed of the cooling fans.– If the WARNING indicator flashes or lights red, see “Warning Indicator” onpage 42( ☞ " Lamp mode " P37 )Selected Input Source and Lamp ModeLamp modeDownloaded From projector-manual.com Sanyo Manuals