46APPENDIXLAMP REPLACEMENTCAUTIONDo not drop a lamp assembly or touch a glassbulb! Glass can shatter and may cause injury.CAUTIONFor continued safety, replace with a lampassembly of same type.Allow a projector to cool for at least 45minutes before you open Lamp Cover. Insideof a projector can become very hot.Check number of lamp to be replaced on Lamp Status Display.Remove two screws on Lamp Cover and press button to openLamp Cover. (See right figure.)13Loosen two screws and pull out Lamp Assembly to be replacedby grasping handle.4Turn off a projector and disconnect AC Power Cord. Allow aprojector to cool down for at least 45 minutes.2Replace Lamp Assembly with a new one and tighten two screws.Make sure Lamp is set properly6Follow these steps to replace lamp assembly.Replace Lamp Cover and tighten two screws.578Connect AC Power Cord to a projector and turn a projector on.Reset Lamp Replacement Counter. (Refer to section "LampCounter Reset" on page 42.)NOTE : Do not reset LAMP REPLACEMENT COUNTER whenlamp is not replaced.BUTTONSCREWSLAMPCOVERSCREWSMake sure which number of lamp needs to bereplaced on Lamp Status Display.Figure shows case of replacing LAMP 2.LAMP 1LAMP 2LAMP 3LAMP 4CAUTION : DO NOT OPERATE A PROJECTOR WHILE ANY OF LAMPS IS REMOVED. IT MAYRESULT IN MALFUNCTIONS, FIRE HAZARD, OR OTHER ACCIDENTS.ORDER REPLACEMENT LAMPReplacement Lamp can be ordered through your dealer. When ordering Projection Lamp, give followinginformation to dealer. Model No. of your projector : PLC-UF10 Replacement Lamp Type No. : POA-LMP42(Service Parts No. 610 292 4831)NOTES ON LAMP REPLACEMENTTo maintain quality of picture (better balance of color and brightness in entire screen), we recommend replacingall 2 lamps at a time.