4Use the Point t u buttons to adjust the gamma value to obtain abetter balance of contrast (from 0 to 15).Press the Point t button to decrease the sharpness of the image;press the Point u button to increase the sharpness of the image(from 0 to 31).An interlaced video signal can be displayed in progressive mode.Press the Point t u buttons to change the progressive scan mode.Off ........... Progressive scan mode is Off.On ........... Progressive scan mode is OnFilm ......... For watching a film. With this function, the projectorreproduces pictures faithful to the original film quality.Noise interference on the screen can be reduced. Press the Pointt u buttons to change the noise reduction mode.Off ........... Noise reduction mode is Off.On ........... Noise reduction mode is On.PNote:• Noise reduction and Progressive cannot be selected whenVideo delay control is set to On (p.63).• Progressive cannot be selected when 480p, 575p, 720p or1080p is selected (p.45).• Noise reduction cannot be selected when 1080p is selected(p.45).To reset the adjusted data, select Reset and press the SELECTbutton. A confirmation box appears and then select yes. Alladjustments will return to their previous figures.To store the adjusted data, select Store and press the Point u orthe SELECT button. Use the Point pq buttons to select one fromImages 1 to 10 and press the SELECT button.A confirmation box appears and then select yes. Stored data canbe called up by selecting an Image (1-10) in the Image ModeSelection on page 46.A confirmation boxappears and thenselect yes.StoreVideo InputPress the Point t button to lighten red/green/blue tone of the blacklevel of an image; press the Point u button to deepen red/green/blue tone of the black level of an image (from 0 to 63).Offset(Red/Green/Blue)SharpnessGammaNoise reductionProgressiveResetStore