6Turn off the projector and unplug the AC power cord. Let theprojector cool for at least 45 minutes.Loosen the screw and open the lamp cover. Loosen 3 screwsof the lamp and pull out the lamp by using the built in handle.1 Replace the lamp with a new one. Make sure that the lamp isproperly and fully inserted.4Connect the AC power cord to the projector and turn on theprojector.Follow these steps to replace the lamp.5PNote:Be sure to insert the lamp in the correct direction.For continued safety, replace with a lamp of thesame type. Do not drop the lamp or touch the glassbulb! The glass can shatter and may cause injury.Allow a projector to cool for at least 45 minutesbefore you open the lamp cover. The inside of theprojector can become very hot.CAUTION CAUTIONWhen the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen andthe Lamp replacement icon appears on the screen andthe Lamp replacement icon appears on the screen andLAMP REPLACE indicator lights orange. Replace the lamp with a new one promptly. The timing when the LAMP REPLACEindicator should light is depending on the lamp mode.Top PanelLAMP REPLACE indicatorLamp replacement iconPNote:The Lamp replacement icon will not appear when the Display function isset to Off (p.52), during "Freeze" (p.30) or "No show" (p.29).Close the lamp cover and secure the screw.LampHandleLamp coverScrewMaintenance and CareNew LampLamp ReplacementWhen replacing the lamp because it has stopped illuminating,there is a possibility that the lamp may be broken.If replacing the lamp of a projector which has been installedon the ceiling, you should always assume that the lamp isbroken, and you should stand to the side of the lamp cover,not underneath it. Remove the lamp cover gently. Smallpieces of glass may fall out when the lamp cover is opened.If pieces of glass get into your eyes or mouth, seek medicaladvice immediately.CAUTIONScrews