Sanyo PLC-XM100/L - 5000 Lumens Manual

Also see for PLC-XM100: Specification sheet Specifications Specifications Network manual Manual

Contents

PLC-XM100/XM100L/XM150/XM150L Expand Serial Command Functional Specifications18/798.4 Image Command8.4.1 CF_ BRIGHT CommandCommand “CF_BRIGHT_%1” [CR]%1“000-063”--------------- Directly specify setting value of Brightness“UP”--------------------- Increment setting value of Brightness by 1“DN”--------------------- Decrement setting value of Brightness by 1DetailsSet user controlled value of Brightness (Available only in the normal Power ONstatus)The value set by this command will not be stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.4.2 CF_CONT CommandCommand “CF_CONT_%1” [CR]%1“000-063”--------------- Directly specify setting value of Contrast“UP”--------------------- Increment setting value of Contrast by 1“DN”--------------------- Decrement setting value of Contrast by 1DetailsSet user controlled value of Contrast (Available only in the normal Power ONstatus)The value set by this command will not be stored in the projector. Therefore, whenthe power is turned to ALL OFF status, the value returns to the original setting. (Itis stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.4.3 CF_COLOR CommandCommand “CF_COLOR_%1” [CR]%1“000-063”--------------- Directly specify setting value of Color“UP”--------------------- Increment setting value of Color by 1“DN”--------------------- Decrement setting value of Color by 1DetailsSet user controlled value of Color (Available only in the normal Power ON status)The value set by this command will not be stored in the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]8.4.4 CF_TINT CommandCommand “CF_TINT_%1” [CR]%1“000-063”--------------- Directly specify setting value of Tint“UP”--------------------- Increment setting value of Tint by 1“DN”--------------------- Decrement setting value of Tint by 1DetailsSet Tint value (Available only in the normal Power ON status)The value set by this command will not be saved to the projector’s memory.Therefore, when the power is turned to ALL OFF status, the value returns to theoriginal setting. (It is stored in Suspend mode.)Acceptable “000” [CR]ResponseUnacceptable “Error Code” [CR]