Sanyo PLC-XM100/L - 5000 Lumens Manual

Also see for PLC-XM100: Specification sheet Specifications Specifications Network manual Manual

Contents

PLC-XM100/XM100L/XM150/XM150L Expand Serial Command Functional Specifications53/799.4.14 CR_NZRED CommandCommand “CR_NZRED” [CR]Details Get Noise Reduction setting statusAcceptable “000_%1” [CR]%1 “OFF” ----------------------------- Cancel Noise Reduction“ON” --------------------------------Set Noise ReductionResponseUnacceptable “Error Code” [CR]9.4.15 CR_PROGV CommandCommand “CR_PROGV” [CR]Details Get Progressive scan setting statusAcceptable “000_%1” [CR]%1“ON” ------------------------------ Set Progressive scan On“FILM” ----------------------------- Select FILM mode“OFF” ------------------------------ Set Progressive scan OffResponseUnacceptable “Error Code” [CR]9.4.16 CR_IMAGE CommandCommand “CR_IMAGE” [CR]Details Get image setting statusAcceptable “000_%1” [CR]%1“STAND” -------------------------------- Standard“REAL” ------------------------------------ Real“CINEMA” ---------------------------------- Cinema“CUSTOM1” ------------------------------- “Image1”“CUSTOM2” ------------------------------- “Image2”“CUSTOM3” ------------------------------- “Image3”“CUSTOM4” ------------------------------- “Image4”“CUSTOM5” ------------------------------- “Image5”“CUSTOM6” ------------------------------- “Image6”“CUSTOM7” ------------------------------- “Image7”“CUSTOM8” ------------------------------- “Image8”“CUSTOM9” ------------------------------- “Image9”“CUSTOM10” ----------------------------- “Image10”ResponseUnacceptable“Error Code” [CR] ------------------------ When the command isinvalid due to condition such as Input source.“?” [CR] --------------------------- When unknown command isreceived9.4.17 CR_IMGGMD CommandCommand “CR_IMGGMD” [CR]Details Get setting status of Standard/Real/Cinema in Image GammaAcceptable “000_%1” [CR]%1“STD” -------------------------------- Standard“REL” ------------------------------------ Real“CNM” ---------------------------------- CinemaResponseUnacceptable “Error Code” [CR]