Sanyo PLC-XU116 - 4500 Lumens Manual

Also see for PLC-XU116: Dimensional drawing Specification sheet Manual Brochure Command list

Contents

PLC-XU116 Expand Serial Command Functional Specifications40/728.10.10 CF_USBTERMINAL CommandCommand “CF_USBTERMINAL_%1”[CR]%1 “DISPLAY” ------------------Select Display“MOUSE” ------------------- Select Mouse controlDetailsSwitch usage of USB terminal.The value set by this command is stored in EEPROM and its setting is effectiveeven after ALL is OFFThis command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.11 CF_CEIL CommandCommand “CF_CEIL_%1”[CR]%1 “ON” ------------------------ Set Ceiling to ON“OFF” ----------------------- Set Ceiling to OFFDetailsSet/Cancel Ceiling setting.The value set by this command is stored in EEPROM and its setting is effectiveeven after ALL is OFFThis command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.12 CF_REAR CommandCommand “CF_REAR_%1”[CR]%1 “ON” --------------------------- Set Rear to ON“OFF” ------------------------- Set Rear to OFFDetailsSet/Cancel Rear setting.When Rear is ON, image is left/right reversed.The status set by this command is stored in EEPROM and its setting is effectiveafter ALL is OFFThis command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]8.10.13 CF_POINTER CommandCommand “CF_POINTER_%1”[CR]%1“SPOTLIGHTMAX” ------------ Select Maximum Spotlight“SPOTLIGHTMID” ------------- Select Medium Spotlight“SPOTLIGHTMIN” ------------- Select Minimum Spotlight“ARROW” ------------------------ Select Arrow“FINGER” ------------------------ Select Finger mark“LASER” -------------------------- Select Laser markDetails Select Pointer styleThis command is available in normal Power ON status.Response Acceptable “000”[CR]Unacceptable “Error Code”[CR]