Sanyo PLC-XU4000 Owner's Manual

Also see for PLC-XU4000: Specification sheet Owner's manual Manual Manual Dimensional drawing

Contents

17InstallationConnecting the AC Power CordThis projector uses nominal input voltages of 100-240 V ACand it automatically selects the correct input voltage. It isdesigned to work with single-phase power systems having agrounded neutral conductor. To reduce the risk of electricalshock, do not plug into any other type of power system.If you are not sure of the type of power being supplied,consult your authorized dealer or service center.Connect the projector with all peripheral equipment beforeturning the projector on.Note:Unplug the AC power cord when the projector is notin use. When this projector is connected to an outletwith the AC power cord, it is in Stand-by mode andconsumes a little electric power.Connect the AC power cord(supplied) to the projector.CAUTIONThe AC outlet must be near this equipment and must beeasily accessible.To the AC outlet.(200 - 240 V AC)NOTE ON THE POwER CORDAC power cord must meet requirement of the country where you use the projector.Confirm the AC plug type with the chart below and proper AC power cord must be used.If supplied AC power cord does not match your AC outlet, contact your sales dealer.To power cordconnector on yourprojector.Projector side AC outlet sideGroundTo the AC outlet.(120 V AC)For the U S A and CanadaTo the AC outlet.(200 - 240 V AC)For the U KFor Continental EuropeGroundDownloaded From projector-manual.com Sanyo Manuals