Sanyo PLC-XW50 Owner's Manual

Contents

Setting47Remote controlThis projector provides two different remote controlcodes: the factory-set initial code (Code 1) and thesecondary code (Code ). This switching functionprevents remote control interference when operatingseveral projectors or video equipment at the sametime.When operating the projector in "Code ", both theprojector and the remote control must be switched to"Code ".To change the code for the projector:Select either "Code 1" or "Code " in this Setting Menu.To change the code for the remote control:Press and hold both the MENU and IMAGE buttonstogether for 5 seconds or more. After changing thecode, make sure the remote control operates properly.Remote controlPress and holdMENU andIMAGE buttonsfor more than 5seconds.SettingOn startW h e n t h i s f u n c t i o n i s " O n " , t h e p r o j e c t o r i sautomatically turned on just by connecting the ACpower cord to a wall outlet.✔ Note:Be sure to turn the projector off properly (see"Turning Off the Projector" on page 19). If theprojector is turned off in the incorrect sequence,the On start function does not operate properly.Lamp controlThis function allows you to change brightness of thescreen.Normal . . . . . normal brightnessAuto . . . . . . . brightness according with theinput signalEco . . . . . . . lower brightness reduces the lamppower consumption and extendsthe lamp life.On start