5-35EO18-33002A5. DIAG. TEST OPERATION (Revision Date: Dec. 20, 2000)5.3 PARAMETER SETTING MODE5.3.5.3 Control Code SelectionPower offPress the [FEED] key.Turn on the power whileholding down the [FEED]key and [PAUSE] key.< 1 D I A G . V 1 . O A>< 2 P A R A M E T E R S E T>Press the [PAUSE] key.Press the [FEED] key four time.P O I T I O NSPress [PAUSE] key three times.Printer parameter setting displayC O E A U T ODP R N T E R P A R AIControl code selectionAUTO : (Automatic selection){ , , } : (Manual selection)ESC, LF, NUL : (Manual selection)Select control code with the[FEED] key or [RESTART]key. (See NOTE 1.)Press the [PAUSE] key.Press the [FEED] keyand [RESTART] keyat the same time.Continued on Section 5.3.5.4Pulse motor speed selection.NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 secondsenables a fast forward.2. A changed control code is stored in memory by pressing the [PAUSE] key.3. When “AUTO”, “ESC”, FL, “NUL”, or “{ , , }“ is selected, be sure to select the Non-transmissive ribbon in the ribbon type selection operation.
