TEC CB-416 Series Maintenance Manual

Contents

TEC CB-416 Series Maintenance Manual Manual pdf 66 page image

5-38EO18-33002A5. DIAG. TEST OPERATION (Revision Date: Dec. 20, 2000)5.3 PARAMETER SETTING MODE5.3.6 Platen Speed Fine Adjustment ModeIf a color misalignment occurs due to paper thickness, elasticity, slack, etc., change the platenspeed to prevent the color misalignment.Power offPress the [FEED] key.Turn on the power whileholding down the [FEED]key and [PAUSE] key.[FEED] key: pressing the [FEED] key onetime is a -1 step change, up to-60 steps. (See NOTE 2.)< 1 D I A G . V 1 . O A>< 2 P A R A M E T E R S E T>[RESTART] key: pressing the [RESTART] keyone time is a +1 step change,up to +60 steps.(See NOTE 2.)+ : Slower— : FasterPress the [PAUSE] key.Press the [PAUSE] key.Press the [FEED] key five time.Press [PAUSE] key.P O I T I O NSP M A D J . + 0P M A D J .Press the [FEED] or[RESTART] key to fineadjust the platen motorvoltage. (See NOTE 1.)Press the [FEED] keyand [RESTART] keyat the same time.Platen speed fine adjustment displayNOTES: 1. This operation is effective when “AUTO” is selected in Section 5.3.5.4 PulseMotor Speed Selection.2. If a color misalignment occurs even after the platen speed fine adjustment, select“104” for the pulse motor speed in Section 5.3.5.4 Pulse Motor Speed Selection.3. Holding the [FEED] key or [RESTART] key down for more than 0.5 secondsenables a fast forward.4. Max. fine adjustment –60 steps = Platen speed fine adjustment value.5. A changed motor voltage value is stored in memory by pressing the [PAUSE]key.