TEC CB-416 Series Maintenance Manual

Contents

TEC CB-416 Series Maintenance Manual Manual pdf 79 page image

5-51EO18-33002A5. DIAG. TEST OPERATION5.5 RAM CLEAR MODEIn RAM clear mode, various data written on the EEP-ROM can be initialized. There are three clearfunctions; Maintenance counter clear, parameter clear and print step clear in the parameter setting mode.After referring to the following table specify and clear or initialize the data.n RAM Clear Mode Table5.5 RAM CLEAR MODEMode NameNO RAM CLEARMAINTE. CNT CLEARPRINT STEP CLEARFunctionIf you enter the RAM clear mode by mistake, specify this mode toeacape from the RAM clear mode without excuting RAM clear.After replacing the print head, cutter module, ribbon feed/rewind motor,solenoid and CPU PC Board, clear the maintanance counter.The following data will be cleared to zero. Confirmation can be madethrough the maintenance counter procedure in self test mode. (SeeNOTE 1)ITEMTotal feed lengthPrint distance (CB-416:black, CB-426:1st)Print distance (CB-416:magenta, CB-426:2nd)Print distance (CB-416:cyan)Print distance (CB-416:yellow)Cut countHead up/down (CB-416:black, CB-426:1st)Head up/down (CB-416:magenta, CB-426:2nd)Head up/down (CB-416:cyan)Head up/down (CB-416:yellow)Ribbon motor driving hours (CB-416:black, CB-426:1st)Ribbon motor driving hours (CB-416:magenta, CB-426:2nd)Ribbon motor driving hours (CB-416:cyan)Ribbon motor driving hours (CB-416:yellow)RS-232C hardware error countInstantaneous power failure countInitial value0 Km0 Km0 Km0 Km0 Km0 time0 time0 time0 time0 time0 hours0 hours0 hours0 hours0 times0 timesITEMPrint head run distance (CB-416:black, CB-426:1st)Print head run distance (CB-416:magenta, CB-426:2nd)Print head run distance (CB-416:cyan)Print head run distance (CB-416:yellow)Initial value0.0 Km0.0 Km0.0 Km0.0 Km