Taie FY400 Operation Manual
                                                                  | |
Contents
| 
9. Basic Function Setting9.1 Input Type SettingPV PVHold key + key 3seconds, to enter LEVEL_31. SV gniwohsyalpsidreppu.2.no-rewopretfayalpsiDSV “INP1” with lower displayshowing current input type.PVPress key the lower PV Press key and3. dednetniehtretneotyek.4SV display flashes. SV input type.PV Modify input type needs to interchange of jumper location,5. Press key to store newSV and it needs to recalibration for linear input type change.value of INP1. Please refer to chapter 15. “Input type modification”.9.2 SV Value Setting1.PVDisplay after power-on. 2.PV When key is pressed,SV the lower display flashes.SV3.PV Press key and 4.PV Press key to store newkey to adjust set value. value of SV.SV SV9.3 Auto Tuning ExecutionPV PV Press key until show1. Display after power-on. 2.SV “AT”。SVPV PV Press key or keyWhen key is pressed,3. SV gninutotuatcelesot.4the lower display flashes. SV execution or not.PV When auto tuning AT LED lamp lit and start to output,5. Press key to store newSV through a few circles to get new PID value with the precisevalue of AT. control, if finished the AT LED will be lamp off.9.4 PID Value SettingPV PVHold key 3 seconds,then entering into LEVEL_21. SV Display after power-on. 2. upper display showing “P1”,SV with lower display showcurrent P1 value.PVWhen key is pressed, PV Press key and3. 1Pdednetniehttesotyek.4SV the lower display flashes. SV value.PV5. SVPress key to store new By the same procedure, use the same ways to set integralvalue of P1. value(I1) and derivative value(D1).17 FY/FU operation manual |
Related manuals for Taie FU400
manualsdatabase
Your AI-powered manual search engine