Taie FY400 Operation Manual
                                                                  | |
Contents
| 
11.2 RetransmissionDescriptionThe retransmission function of the FY series controller can provide digital values for parameters such as SV or PV etc.Analog signals are transmitted to external devices according to the set range (EX: PLC AI module, inverter, etc.).transmission output signal selectable: 4~20mA, 0~20mA, 0~5V, 0~10V, 1~5V, 2~10VFunction DiagramPV 100.0SV200.0Sensor input Retransmission outputOUT1 OUT2 ATAL1 A L2 AL3M AN PROOUT1 %0 20 40 60 80 100Electric SET A/Mfurnace TAIE FY900Sensor12.00mAammeterParameterParameter Symbol Content Range Default Level Hide/yalpsiDNIMXAMSET9.3 0 : Retransmission SV disable 1 0 0 Level 4 ---1 : Retransmission SV enableSET9.4 0 : Retransmission PV disable 1 0 0 Level 4 ---1 : Retransmission PV enableCLO3 Retransmission zero calibration 9999 0 0 Level 3 SET5.2CHO3 Retransmission span calibration 9999 0 3600 Level 3 SET5.2ExamplesAssume the input range (LSPL & USPL) = -50.0~600.0 retransmit PVWhen the PV value is between -50.0 and 600.0, the retransmission signal is based on the PV value,and the linear output analog signal is presented.When the PV is less than -50.0, the retransmission signal remains at 4mAWhen the PV value is greater than 600.0, the retransmission signal remains at 20mAParameter settingLevel Parameter Set value Description3 SET9.4 1 Retransmission PV3 CLO3 3133 Retransmission signal low point calibration value(each controller calibrate value is different)3 CHO3 3508 Retransmission signal high point calibration value(each controller calibrate value is different)mA20 Measuredvalue(PV)40 Scaling value50.0(LSPL) 200.0(USPL)Notes1. To order TRS function, please confirm the type of retransmission output signal and retransmit signal range.2. The user can select the source to be transmitted according to the parameter SET9.4 or SET9.3. The factory default isto retransmit the PV.3. Modify the parameter INP1/UNIT will reset the retransmission range.4. CLO3 & CHO3 are the calibration parameters of the re-transmission signal. It has been calibrated before leaving the factory.Do not change this parameter value.5. The user only needs to set SET9.4 or SET9.3, the rest of the parameters will be set & calibrated at the factory.33 FY/FU operation manual |
Related manuals for Taie FU400
manualsdatabase
Your AI-powered manual search engine