Taie FY400 Operation Manual
                                                                  | |
Contents
| 
13.3 Program Initial SettingProgramInitial SettingProgram time formatProgram executestart addressProgram execute withrepeat function ?Program execute withpower fail function ?Program execute withwait function ?1. Setting program time formatParameter noitpircseDyalpsidDEL Default LevelProgram time formatSET9.2 0 4leveL0etunim.ruoh:1 : minute.secondThis parameter determines the time format of timer during program executionWhen SET9.2 =0 , TM_n=33.23, it indicates that the execution time of this segment is 33 hours and 23 minutes WhenSET9.2 =1 , TM_n=33.23, it indicates that the execution time of this segment is 33 minutes and 23 seconds2. Setting program execute start addressParameter noitpircseDyalpsidDEL Default LevelSET8.3Program execute start address0 4leveL1orezmorfetucexe:1 : execute from current PV,cut timeWhen program starts, SV initial value will execute according to SET8.3 set value(1) SET8.3 =0, PTN=1 PV=50.0 SV_1=100 TM_1=1.00(1 hour)When program starts, SV will start to execute from 0.0, and SV shall reach SV_1 in one hour(2) SET8.3 =0, PTN=1 PV=50.0 SV_1=100 TM_1=1.00(1 hour)When program starts, SV will start to execute from PV temperature of 50.0, while controller will deduct the timetaken to go from 0.0 to 50.0, and SV shall reach SV_1 in half hour3. Setting program execute with repeat functionParameter noitpircseDyalpsidDEL Default LevelProgram execute repeatSET8.1 0 4leveL0noitcnuftaeperelbasid:1 : Program execute repeatWhen program completes the execution of the final segment, and “END” message is not shown, the program will beexecuted again.4. Setting program execute with power failure protection functionParameter noitpircseDyalpsidDEL Default LevelSET8.2Program execute power fail protection0 4leveL0noitcetorpliafrewopelbasid:1 : enable power fail protectionpower failure during program execution, if there is power failure protection function set,controller will execute current segment program after booting finishAssume power failure occurring in the segment_4, ramp temperature from 100°C to 200°C, and power failureoccurring at SV=125, the program will execute from 100°C (segment_4), after controller booting finish49 FY/FU operation manual |
Related manuals for Taie FU400
manualsdatabase
Your AI-powered manual search engine