Chapter 5 Extended Features5-215.5 Using the Custom Paper SizeFeatureUse the front panel to select the correct custom size paper for Tray 1. Withinthe Paper menu, Media Size/Type , Tray 1, you first need to turn auto sense tooff, then set the width and height of the paper to be used. Then select useCustom paper size to on.Then you should select the custom size paper within the driver. An examplebelow is shown using the Postscript driver.5.5.1 Operator Panel AccessThe Paper Menu provides access to the Custom Paper Size settings for tray 1.The allowable range for setting a custom paper size is:Use the following procedure to enter the Paper Menu to set a Custom PaperSize:1. Set Auto Sense in the paper menu for tray 1 to Off.2. Press the MENU button on the control panel.3. Press the NEXT button until the text “Paper Menu” is shown on the sec-ond line of the display.4. Press the SELECT button to enter the Paper Menu.5. Press the NEXT button until the text “Media Size/Type” is shown onthe second line of the display and press the SELECT button.6. Press the NEXT button until the text “Tray 1” is shown on the secondline of the display.7. Press the SELECT button.8. Press the NEXT button until the text “Custom Size” is shown on thesecond line of the display.9. Press the SELECT button to enter the “Custom Size” menu. “Width” isshown on the second line of the display.10. Press NEXT or PREVIOUS to increase or decrease each digit of thethree-digit number to set the width of your paper. When the width of paperis correct, press the SELECT button.11. Next “Length” is shown on the second line of the display.Paper Width simplex 100 – 215.9 mm (3.9 – 8.5 inches)duplex 176 – 215.9 mm (176 – 8.5 inches)Paper Length simplex 210 – 297 mm (8.3 – 11.7 inches)duplex 250 – 297 mm (9.8 – 11.7 inches)
