User guide Settings44Selecting characterdensity and font(temporarily)You can use the CPI (Character Per Inch) key in setup mode to sel-ect the number of characters per inch to be printed.You can use the Font key to select resident fonts.Press the Setup key. The printer changes to setup mode.Press the Char (4) key.Press the CPI (4) or Font (1) key (in our example, press CPI).Use the < (2) or > (3) key to set the desired character density. Con-firm the selection by pressing the Set (1) key.You can cancel the selection and leave the setting unchanged bypressing the Exit (4) key.If you pressed the Font (1) key, use the < (2) or > (3) key to selectthe desired font. Confirm the selection by pressing the Set (1) key.You can cancel the selection and leave the setting unchanged bypressing the Exit (4) key.Press the Setup key. The printer returns to the initial status.It is also possible to press the Online key. The printer then changesdirectly to online mode.The selection made will not be retained after switching off theprinter. For more details on how to set fonts permanently,please refer to the chapter Selecting font (Font) (page 53).Adjust PaprpathMenu Char OnlineSetup21 3 4Font CPIOnlineSetup21 3 410 CPI *Set < > Exit OnlineSetup21 3 4ROMAN HQSet < > Exit OnlineSetup21 3 4Adjust PaprpathMenu Char OnlineSetup21 3 4
