User guide The Menu78Increasing the print head gap(Head up)With this function you can increase the print head gap before and af-ter the perforation of the form.Setting options: On/OffDefault setting: OffIf the parameter is set to On, the print head gap increases duringform feed and line feed four lines before and after the perforation onthe form (= protected zone). The print head gap is always increasedduring form feeding past the perforation even when feeding takesplace outside the protected zone.Printing is possible in the protected area.Confirm the setting by pressing the Set (1) key.Paper width (Pagewid) This parameter determines the actual paper width.Press the Pagewid key (3).Setting options: From 20 to 136 in 1/10 inch stepsDefault setting: 136/10 Zoll (136 characters at 10 characters/inch)If Head up = On, the print head moves to the calculated center ofthe paper during the time the paper is moving in the protected zone.If Rightzo = On (see below), the print head moves out of the perfo-ration zone on the right as long as the paper is being transported.Set the printing width rather than the actual paper width.Confirm your settings with the Set key (1) and press the Next key(4) to access the next group of parameters.Head up=Off *OnlineSetupSet < > Exit21 3 412234567 81 Top edge of form 5 Protected zone2 Paper transport strip 6 Transport holes3 Bottom edge of form 7 Left-hand area4 Form separation perforation 8 Right-hand areaHead up PagewidOnlineSetupBack Next21 3 4Pagewid=136/10“*OnlineSetupSet < > Exit21 3 4
