TASCAM DR-40 10514 – MessagesThe following is a list of the popup messages that might appear on the DR-40 under certain conditions. Refer to this list if one ofthese popup messages appears and you want to check the meaning or determine a proper response.Message Meaning and responseFile Name ERR The DIVIDE function would cause the file name to exceed 200 characters. The DIVIDE function adds “a” or “b” to the end ofthe original file name. Before choosing the DIVIDE function, connect the unit to a computer and edit the file name to lessthan 200 characters.Dup File Name The DIVIDE function would cause the file name to be the same as that of an existing file. The DIVIDE function adds “a“or “b” to the end of the original file name. Before choosing the DIVIDE function, connect the unit to a computer andedit the file name.File Not Found The file added to the playlist cannot be found or a file could be damaged. Please check the file in question.Non-Supported The audio file is not a supported format. Please see “11 - Connecting with a computer” for file formats that this unitcan use.Battery Empty The battery is almost out of power. Replace the AA batteries.I/O Too Short The IN and OUT points are too close together. Reset the IN and OUT points with at least 1 second between them.File Not FoundPLAYLISTThe file in the Playlist cannot be found. Please confirm that the file is still in the Music Folder.No PLAYLIST No files have been added to the Playlist. Add a file to the Playlist or change the play mode to something besidesPLAYLIST.PLAYLIST Full The playlist is full. You cannot add more than 99 files to the Playlist.MBR Error Init CARDThe card is not formatted properly or the formatting is broken. Change the card or press the ENTER/MARK buttonwhen this message appears to format the card in FAT format.CAUTION: Execution of FAT formatting erases all data currently on the card.Format ErrorFormat CARDThe FAT formatting of the card is abnormal or broken. This message also appears if you FAT formatted the cardusing a computer connected by USB and if a new card is inserted in the unit. Always use the DR-40 to conduct FATformatting of cards to be used with it. Change the card or press the ENTER/MARK button when this messageappears to format the card in FAT format.CAUTION: Execution of FAT formatting erases all data currently on the card.