34 TASCAM DR-403 – Preparation3 Use the + or − button to select (highlight) MIC LR SWAP,and press the ENTER/MARK button.The MIC LR swap screen will appear.4 Use the + button or – button to select (highlight) L-R orR-L depending on the microphone pair’s status.5 Press the ENTER/MARK button to fix the setting, and toreturn to the Home Screen.Microphone position detectionThe following pop-up message appears automaticallywhenever the right microphone is opened or closed and theleft-right channels does not suit the angle of the microphone.If only the left microphone is opened or closed, it does notappear.Press the ENTER/MARK button to change the setting.Press the (HOME) [8] button to leave the setting as it is.NOTE• When you change the microphone angle setting and thepop-up message appears, you must press the ENTER/MARKbutton to change the L–R setting, press the (HOME)[8] button to keep this setting as is, or restore the previousmicrophone angle to close the pop-up message before youcan begin recording.• The pop-up message does not appear if you change themicrophone position when recording. If necessary, usethe MIC LR SWAP setting by pressing the QUICK buttonto switch the setting after change the setting to recordingstandby mode by pressing the RECORD [0] button.Attaching the tilt footWhen recording with the built-in mics, placing the recorderwith the battery compartment cover side down will causethe built-in mic orientation to be low. You can attach theincluded tilt foot to the tripod threads in order to keep the micorientation from being too low.Attach it as shown below.
