76 TASCAM DR-406 – PlaybackRepeated Playback of Selection (Loop Playback)With this function, you can continuously repeat (loop) theplayback of a selection that you make.1 While the Home Screen is open when stopped orplaying back, press the PB CONT button to open thePlayback Control screen.2 Press the PLAY [7] button to start playback, andpress the ENTER/MARK button at the start point ofthe section that you want to play repeatedly. Thisposition is set as IN (start) point. Then, appears at thecorresponding point on the playback indicator bar.3 Press the ENTER/MARK button at the end point of thesection that you want to play repeatedly. This positionis set as OUT (end) point. Then, appears at thecorresponding point on the playback indicator bar.Loop playback of the section between the IN and OUTpoints starts.During loop playback the indicator also appears.Press the PB CONT button to return to the Home Screenwhile maintaining the I/O and loop settings effective.Even after returning to the Home Screen, the iconcontinue to be shown, along with the and marksshown at the points corresponding to the IN and OUTpoints on the playback indicator bar.NOTE• The pop-up message of I/O Too Short appears if thesection between the IN and OUT points is too short. Setthem again. The section should be 1 second or longer.• Press the ENTER/MARK button again to clear the IN andOUT points.• To stop loop playback, press the MENU button when thePlayback Control screen is open. Press the MENU buttonagain to start loop playback between the set IN and OUTpoints.• You cannot set the IN and OUT points in different files.• The previous IN and OUT point settings are lost when youset the IN point on a different file.• Accurate assignment of IN and OUT points is not alwayspossible for variable bit rate (VBR) MP3 files.
