TASCAM HS-2000 415 – ProjectsEditing the name of the first sessionTouch the Session Name button on the CREATEPROJECT screen to open the 1st SESSION screen,as shown below.Follow the same procedures as in “Editing project names”on page 40 to change the name.NOTEThe name of a session cannot be changed after thesession is created.Loading projects1. Press the PROJECT key on the front panel to open thePROJECT screen.2. Select the project to load.3. Touch the MENU button on the PROJECT screen toopen its pull-up menu.4. Touch the LOAD button in the pull-up menu.NOTEWhen multiple projects are selected, the LOAD itemcannot be used.5. Touch the OK button or press the DATA dial when theconfirmation pop-up message appears.After loading completes the Home Screen opens.Rebuilding projectsYou should rebuild a project whenever there is aninconsistency between the unit's project management fileand the audio files. This can occur when an audio file hasbeen deleted from the unit via FTP, for example.1. Press the PROJECT key on the front panel to open thePROJECT screen.2. Select the project that you want to rebuild.You can use the MULTI SELECT button on thePROJECT screen to allow the selection of multipleprojects.3. Touch the MENU button on the PROJECT screen toopen its pull-up menu.One project selectedMultiple projects selected4. Touch the REBUILD button in the pull-up menu.5. When a confirmation pop-up appears, touch the OKbutton or press the DATA dial.During rebuilding, a progress status pop-up appears.When rebuilding completes, the pop-up disappears.NOTEIf you select REBUILD when no project has beenselected in the PROJECT screen, the entire content ofthe selected card will be rebuilt.
