74 TASCAM HS-20008 – Take modeBWF-J cue point (take mode)When the Follow BWF-J item is set to ON, if a BWF-Jcue point is detected during playback, the followingcorresponding operation will occur. In addition, if theBWF-J Tally Out item is set to ON, in response to eachBWF-J cue point, the cue signal and tally signal will beoutput from the parallel remote connector.BC$STANDBYWhen a take is loaded, the transport locatesto the first BC$STANDBY point as the playbackstart point. During playback, playback pauseswhen this cue point is detected. In either case,a BC$STANDBY tally is output.BC$CM During playback, when this cue point isdetected, a BC$CM CUE signal is output.BC$END During playback, when this cue point isdetected, a BC$END CUE signal is output.BC$STOP During playback, when this cue point isdetected, a BC$STOP CUE signal is output, andplayback stops.BC$FILEDuring playback, when this cue point isdetected, a BC$END CUE signal is output. Ifthere is a BC$STANDBY cue point in the nexttake, playback will move to it and pause at thatpoint. A BC$STANDBY tally is output.BC$PAUSEDuring playback, when this cue point isdetected, a BC$PAUSE tally is output, andplayback pauses.Using the flash start functionFlash start playback is possible using a TASCAM RC-HS32PD or RC-HS20PD (sold separately) or other remotecontroller.For details, see “Flash start function” on page 130.Take operationsMultiple takes can be created in the same session folder.For details about project and session operations, see“5–Projects” on page 35.The following operations are possible with takes.Change take start times•Export takes•Delete takes•Sort takes•Change the order of takes•Edit take names•Divide takes•Combine takes•Undo the previous edit•Redo the cancelled edit•Changing the start time of a take1. Press the PROJECT key on the front panel to open thePROJECT screen.2. Touch the w button for the project that contains thetake for which you want to edit the start time to openthe session selection screen.If the selected project is not the current project, a pop-up window appears confirming that you want to loadit. Touch the OK button.3. Touch the w button for the session that contains thetake for which you want to edit the start time to openthe take selection screen.If it is not the current session, a pop-up windowappears confirming that you want to load it. Touch theOK button.NOTETo load a take from the current session, instead of steps2–3, touch the session name button at the top right ofthe project screen, or touch the take name button on theHome Screen, and touch the TAKE List button in the pull-down menu to open the take selection screen for thecurrent session.4. Select the take for which you want to edit the starttime.5. Touch the MENU button on the take selection screento open a pull-up menu.6. Touch the EDIT TC button in the pull-up menu toopen the TAKE TC screen.
